Page 2 - Inert Gas Fire Extinguishing System

SWASTIK SYNERGY ENGINEERING PVT. LTD.

Temperature Range:
SYNERT 200 BAR / 300 BAR INERT GAS SYSTEM
The components are designed and tested to operate in the
SYNERT GAS SYSTEM is the safe, natural way to extinguish a fire. temperature range -20 °C to 50 °C or as stated in separate
SYNERT GAS SYSTEM is safer and more economical than any component listings.
other system on the market.
SYNERT Agents:
Under normal conditions SYNERT agents is an odourless
SYNERT GAS SYSTEM: THE LATEST TECHNOLOGY colourless gas.

SWASTIK SYNERGY has introduced an improvement in systems SYNERT Gases do not support combustion, nor have an impact
using IG-01,IG-55,IG-100,IG-541 as the extinguishing agent with on the ozone layer, and has no global warming potential. Inert
the latest technology, providing benefits to the facility itself and Gases are supplied as under:
the protected enclosure.
Name of Gas Contents
This innovative technology enables to optimize the design of the
SYNERT IG-01 Argon
firefighting system with IG-01,IG-55,IG-100,IG-541 as the
SYNERT IG-55 50% Argon, 50% Nitrogen
discharge pressure and flow control allow users to reduce the
size of tubing needed for proper distribution of the agent and SYNERT IG-100 Nitrogen
reduce overpressure that take place in the protected enclosure, SYNERT IG-541 52% Nitrogen, 40% Argon, 8% Co2
minimizing the area for the relief of excess pressure.
Storage containers are designed to hold agent in gaseous form at
SYNERT systems are designed to suppress fires involving class
a nominal pressure of 200 bar or 300 bar at 15 °C.
A, B and C hazards. The systems are designed to be total
Handling and Installation of SYNERT equipment should only be
flooding and consist of a fixed supply of agent connected to a
carried out by persons experienced in dealing with this type of
piping system with nozzles to direct the agent into an enclosed
equipment. The following specification applies to SYNERT
hazard. Inert gas extinguishes fires by lowering the oxygen
agents:
content below the level that supports combustion. In simple
terms if the oxygen content of the atmosphere is reduced to a
level below 15%, most ordinary combustibles will not burn. Since SYNERT AGENT SPECIFICATION
SYNERT agents are stored as a gas, it discharges as an invisible
gas, allowing people to safely exit a protected space without Pressure
295 Bar – 300 Bar at 15° C
obscured vision. (300 Bar System)
SYNERT gas systems are particularly valuable in extinguishing Pressure
195 Bar – 200 Bar at 15° C
fires in enclosures containing hazards or equipment where a (200 Bar System)
clean, electrically non-conductive medium is essential or where Moisture Max 12 ppm
the cleaning up of foam, water or powder would be problematic.

HOW IS IT ACTUATED?
MAXIMUM PROTECTION, MINIMUM STORAGE
The extinguishing principle of inert gases focuses on reducing
SYNERT GAS SYSTEM containers allow you to protect single- or
oxygen concentration in the affected zone. When a fire starts
multiple-hazard areas typically requiring less floor space than
SYNERT Gases rapidly penetrates the area and reduces the
other inert gas systems.
oxygen level percentage from the usual level of 21% to a limit that
Think of the cost savings! fluctuates between 13% and 11%, the amount sufficient for
You no longer need to purchase, install and maintain several combustion to stop and to be safe for the people in the room. Due
individual protection systems for your multi-risk facility. One to the stratification of the gases, protection is achieved
SYNERT GAS SYSTEM does it all. throughout the space, regardless of how high the ceiling is.
During its discharge, there is excellent visibility and, since it
leaves no residue, there are no destructive effects to the
equipment, which will continue functioning normally and, of
course, there will be nothing to clean up.

02 www.swastiksynergy.com